Premium Quality Ceiling Flat Application Guide
 Paint Tech Premium quality Ceiling Flat is premium flat water borne interior paint for use on ceilings. It is scientifically designed for easy application and has excellent opacity. One coat will give a satisfactory appearance in most cases.
Use on
Interior ceilings
Application
Short nap roller, brush or spray. One coat is usually sufficient when repainting in the same or similar colour.
Coverage
Approximately 16 square meters per litre, depending on the nature of the surface. Spreading rate on rough or absorbent surfaces will be lower. Drying and recoating Normally dries to touch in 30 minutes and may be recoated after 2 hours at 25°C and 50% RH. Under cooler or humid conditions, allow longer times. Do not use in temperatures below 10°C.
Surface preparation
Scrape off loose and flaking paint. Wash with sugar soap. Fill nail holes, cracks etc, with a suitable filler. Sand smooth and dust down. Paint these areas with Paint Tech Easy Sand Sealer Undercoat. Sand gloss and semi-gloss surfaces thoroughly , wipe clean.
Brush down to remove dust. Apply 1 coat of Paint Tech Easy Sand Sealer Undercoat. New plaster, fibrous plaster, plasterglass Brush down with a stiff fibre brush. Fill cracks with a suitable filler, sand and dust down. For new plaster. fibrous plaster and plasterglass . paint filled areas with Paint Tech Easy Sand Sealer Undercoat.
Thinning
Not usually required. On very absorbent surfaces e. g. set plaster, or on very hot days, dampen the surface and thin the first coat with up to 100ml of water per litre .
Clean up
Water, clean equipment immediately after use.
Care of new paintwork
Avoid exposure to steam and condensation for 48 hours after painting. May be lightly cleaned with a sponge wet with detergent solution after 7 days. |
• Use on
• Application
• Coverage
• Surface preparation
• Thinning
• Clean up
• Care of new paintwork
|
Need help with colours? See our colour guide.
